![]() ![]() The other end of the shaft fits through a hole in the lockplate, and on this end is forged a cam, or eccentric. ![]() The outside projection is of square section to permit a spanner (wrench) to be engaged for subsequent tensioning of the lock. The wheel is fixed to a shaft, one end of which projects outside the lockplate. The wheel is grooved on its outside circumference with three or more V-shaped grooves with transverse cuts at intervals to provide a friction surface for the iron pyrite. The upper segment of the grooved wheel, made of hardened steel, projects through a slot cut to its precise dimensions in the base of the priming pan. Flint is not suitable as a sparking material in the wheellock because it is too hard and would quickly wear away the wheel grooves. The dog has two possible positions to which it can be pivoted by hand: a "safe" position, in which the dog is pushed towards the muzzle of the firearm, and an "operating" position, where the dog is pulled towards the operator so that the pyrite in its jaws can engage either the top of the pan cover (see below), or (in the absence of the pan cover) the edge of a steel wheel bearing longitudinal grooves around its circumference. A sparking material, usually a small piece of iron pyrite, is clamped and held by vise-like jaws at the swinging end of the arm. The dog is a spring-loaded arm pivoted on the outside of the lock plate. On the other hand, wheellock mechanisms were complex to make, making them relatively costly.ĭetail of the mechanism, with the wheel visible under the dog When the trigger is pulled, the pan cover is opened, and the wheel is rotated, with the pyrite pressed into contact.Ī close modern analogy of the wheellock mechanism is the operation of a lighter, where a toothed steel wheel is spun in contact with a piece of sparking material to ignite the liquid or gaseous fuel.Ī wheellock firearm had the advantage that it can be instantly readied and fired even with one hand, in contrast to common matchlock firearms, which must have a burning cord of slow match ready if the gun might be needed and demanded the operator's full attention and two hands to operate. The pyrite is clamped in vise jaws on a spring-loaded arm (or 'dog'), which rests on the pan cover. The wheellock works by spinning a spring-loaded steel wheel against a piece of pyrite to generate intense sparks, which ignite gunpowder in a pan, which flashes through a small touchhole to ignite the main charge in the firearm's barrel. ( March 2015) ( Learn how and when to remove this template message) Unsourced material may be challenged and removed. Please help improve this section by adding citations to reliable sources. ![]()
0 Comments
Leave a Reply. |